1200 x 600 x 50mm board providing up to 4 hours fire rating
Intubatt is a factory finished, unique multi-layered, low resin bonded, rock mineral fibre board. Firetherm ablative coated on both faces with our unique Optifire-identifiable coating. Manufactured under controlled factory conditions to ISO 9001 to the required thickness and specification. Intubatt may be over coated using a suitable emulsion or eggshell paint for decorative purposes.
Firetherm Intubatt should be used to seal openings in fire compartment walls and floors around services
such as suitably supported fire rated dampers, pipe work and electrical cabling against the passage of fire and can provide up to 4 hours integrity in Block-work and up to 120 minutes integrity, and Insulation in drywall situation.
For the Product Data sheet for this product please click here
For the material safety data sheet on the product please click here
This product is delivered with full health and safety information and data sheet. All of our products are fully tested meeting the highest quality standards.
All orders are usually despatched within 24 hours of receiving cleared payment (Mon–Fri).
The above information is based on current test data, health and safety information and application instructions supplied by our suppliers and manufacturers of the products. It is supplied for guidance and to the best of our knowledge is true and accurate. Customers should satisfy themselves to the suitability of the products in its intended use and no guarantee is given or implied as the conditions of actual use are beyond our control. If in doubt the customer should consult the designer of the project or the local building control.
Fire Stopping Shop, disclaim any liability for loss, damage or other expense which may arise from the use of this information, data or products refereed to and reserve the right to amend or change any details without notice. This statement does not affect your statuary rights.